Thanks to @miau9202, @Jhyrachy & @Fiqusny
Prerequisite:
>Root
>BusyBox Installed
>ADB driver installed
>USB debugging activated in 'Developer Settings'
How To:
>Connect your phone while switched on to your pc
>Run "1.bat"
-You need to press a button after each passage, to proceed. This is done for debugging purpose, so that if you have an error you have the possibility to copy it
-NOTE: the error "WARNING: linker: could not load library "libsigchain.so" from LD_PRELOAD for "gz
ip"; caused by library "libsigchain.so" not found" is NORMAL, you can simply ignore it and proceed
Your phone will reboot and after a while (it could require even 10 minutes), it should appear the "Android Upgrade" pop-up.
Wait for him to complete and then you are ready to go!
After that install xposed framework.
XDA and We are not responsible for any loss, do it on your own risk.
Prerequisite:
>Root
>BusyBox Installed
>ADB driver installed
>USB debugging activated in 'Developer Settings'
How To:
>Connect your phone while switched on to your pc
>Run "1.bat"
-You need to press a button after each passage, to proceed. This is done for debugging purpose, so that if you have an error you have the possibility to copy it
-NOTE: the error "WARNING: linker: could not load library "libsigchain.so" from LD_PRELOAD for "gz
ip"; caused by library "libsigchain.so" not found" is NORMAL, you can simply ignore it and proceed
Your phone will reboot and after a while (it could require even 10 minutes), it should appear the "Android Upgrade" pop-up.
Wait for him to complete and then you are ready to go!
After that install xposed framework.
XDA and We are not responsible for any loss, do it on your own risk.
No comments:
Post a Comment