Hello there
I own a sanei N90 which had a broken touchscreen. After ordering i noticed a difference in the newly arrived screen which only had 50 pins instead of 60 pins. But I connected it and it works.
The only problem is there is a noticable offset on the point where I push it. Eg. If i push somewhere the registered x value is 200+ the normal value and y is somewhere around 150+.
I've been searching around for a way to adjust this, maybe calculate it and change it in the setting because it is the only thing wrong with the new screen.
Maybe someone has a little more insight in this matter?
Kind regards
I own a sanei N90 which had a broken touchscreen. After ordering i noticed a difference in the newly arrived screen which only had 50 pins instead of 60 pins. But I connected it and it works.
The only problem is there is a noticable offset on the point where I push it. Eg. If i push somewhere the registered x value is 200+ the normal value and y is somewhere around 150+.
I've been searching around for a way to adjust this, maybe calculate it and change it in the setting because it is the only thing wrong with the new screen.
Maybe someone has a little more insight in this matter?
Kind regards
No comments:
Post a Comment