Is possible to confirm the issue I am experiencing is due to thermal sensor? if so. is it possible to change the default threshold using adb or some other method that would not require booting the rom.
When I plug the phone in to charge I get a your device is overheated, charge will resume when cooled down, etc. message.
When I try to boot I receive the custom animation and then flash of the ROM starting up abruptly followed by shutting down.
I ran a dumpstate and found the following:
LGE charging scenario : state 0 -> 3(2-1), temp=79, volt=4326, BTM=1, charger=1, cur_set=1600/-1, chg_cur = 26
I'm not sure but I believe the temp should be closer to 25...
running XDABBEB 3.1.2
When I plug the phone in to charge I get a your device is overheated, charge will resume when cooled down, etc. message.
When I try to boot I receive the custom animation and then flash of the ROM starting up abruptly followed by shutting down.
I ran a dumpstate and found the following:
LGE charging scenario : state 0 -> 3(2-1), temp=79, volt=4326, BTM=1, charger=1, cur_set=1600/-1, chg_cur = 26
I'm not sure but I believe the temp should be closer to 25...
running XDABBEB 3.1.2
No comments:
Post a Comment